Deprecated: Creation of dynamic property cls_session::$session_data_table is deprecated in /www/sites/www.188bio.com/index/systems/cls_session.php on line 49
AccuStandard/2,2'-Dichlorobiphenyl/C-004N/25 mg188bio精品生物—专注于实验室精品爆款的电商平台 - 蚂蚁淘旗下精选188款生物医学科研用品
您好,欢迎您进入188进口试剂采购网网站! 服务热线:4000-520-616
蚂蚁淘商城 | 现货促销 | 科研狗 | 生物在线
产品资料

AccuStandard/2,2'-Dichlorobiphenyl/C-004N/25 mg

Additional Information

Storage Condition
Ambient (>5 °C)
Safety Data Sheet
Certificate of Analysis
 
 
Analyte CAS Number Target Concentration
2,2'-Dichlorobiphenyl 13029-08-8 N/A

2,2'-Dichlorobiphenyl

Double click on above image to view full picture

Zoom Out
Zoom In
Molecular Formula
C12H8Cl2
Molecular of Weight
223.10
Melting Point (°C)
140-142 °F / 60-61 °C
Boiling Point (°C)
594 °F / 312 °C
Flash Point (°C)
>210 °F / >100 °C
 
 
Symbol
Signal word
Danger
Hazard statements
May cause liver damage. (Specific target organ toxicity, single exposure, category 2)
The consistent finding in animal studies with PCB’s is that they produce liver injury and are suspected of causing cancer following prolonged and repeated exposure by any route, if the exposure is of sufficient degree and duration. Liver injury is produced first, and by exposures that are less than those reported to cause cancer in rodents. Therefore, exposure by all routes should be kept sufficiently low to prevent liver injury. (Carcinogenicity, category 1B)
May cause long-term adverse effects in the aquatic environment. (H413)
Harmful if swallowed. (Acute toxicity, oral, category 4)
Harmful if inhaled. (Acute toxicity, inhalation, category 4)
Irritating to skin. (Skin corrosion/irritation, category 2)
Harmful if absorbed through skin. (Acute toxicity, dermal, category 4)
This product is or contains a component that is classified (ACGIH, IARC, NTP, OSHA) as a possible cancer hazard. (Carcinogenicity, category 1B)
California Proposition 65 Warning: This product contains a component (or components) that may cause cancer and genetic effects in a concentration greater than or equal to 0.1%.
Precautionary statements
Eye contact: Immediately flush with plenty of water. After initial flushing, remove and contact lenses and continue flushing for at least 15 minutes. Assure adequate flushing by separating the eyelids with fingers.
Skin contact: Immediately wash skin with soap and plenty of water. Remove contaminated clothing. Get medical attention if symptoms occur. Wash clothing before reuse.
Inhalation: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical attention.
Store in a tightly closed container.
Do not breathe dust.
Do not get in eyes, on skin or clothing.
This product should only by used by persons trained in the safe handling of hazardous chemicals.
Wash thoroughly after handling. Do not take internally. Eye wash and safety equipment should be readily available.
Respiratory Protection: If workplace exposure limit(s) of product or any component is exceeded (see TLV/PEL), or a risk assessment shows air-purifying respirators are appropriate, use of a NIOSH/MSHA approved air supplied respirator is advised. Use a full-face respirator with multi-purpose combination (US) or type ABEK (EN14387) respirator cartridges in absence of proper environmental control. Always use respirators and components tested and approved under appropriate government standards such as NIOSH (US) or CEN (EU). Engineering and/or administrative controls should be implemented to reduce exposure.
Protective gloves must be worn to prevent skin contact.
 
 
UN Number
UN3432
Class
9
Packing Group
II
新闻动态
行业前沿
技术文章
最新产品